本帖最后由 風中之翼 于 2015-5-7 16:26 編輯
$ ~9 J0 l& K& ?+ K
% J2 b+ F0 `* V. u如圖，這是溫水洗凈坐便器（就是前一段很火的好多去日本買的那個）沖洗壓力測試的JIS標準，原文如下) {- i4 i% \6 |
# C# ^: G9 f/ p" `9 w2 Y. l% F9 z性能要求：
: W! I Q: O' x" a7 Q0 H% Q6.1.3 Rear washing force+ A ]( U" H( v9 W- G# ^
The rear washing force shall be such that the total pressure receiving area by washing water is 0.06 N or over, and the washed area is 80 mm2 or over when tested in accordancewith 9.3.3.9 s6 y9 Q# \, N. C8 U+ j- e
/ ]" d# g+ i8 U8 \2 S, F測試方法( s- H- A0 G! x: Z; }: a$ I
9.3.3 Rear washing power
/ {7 V$ j; k* ?% e& EThe rear washing force measurement shall be as follows:# [1 h% g* K/ b! j9 |* J2 _
a) Set the washing water temperature and quantity control both to the maximum. Operate washing for 30 s. Measure the total receiving pressure of the washing water at the flood level toilet rim for any 2 s using equipment as shown in Figure 1, and then,6 e- s5 I$ ~8 U6 A0 y+ d' ^/ j
as shown in Figure 2, read the maximum value and the minimum value of the pressure load, The mean value of the two is read as the centre value. The pressure receiving board shall be circular and have sufficient area for receiving the whole washing water.
8 z) ?/ a* X$ k3 Y7 s, Y$ z
2 r. G- O* f- Q5 q; i求助問題：測試中用到的壓力測量傳感器用哪種規格適合？ |
發表于 2015-5-7 16:24:20
QQ好友和群
QQ空間
